CAN-BUS RESISTOR CBW1

CAN-BUS RESISTOR CBW1

HIGHSIDER CAN-BUS resistor CBW1 with DIP-switch.Our newly developed HIGHSIDER CAN-BUS resistor CBW1 fits most vehicles that have a CAN-BUS system.The CBW1 resistor provides a required electrical load for your vehicle, which, if the dip switches are set correctly, will result in no flashing of the accessory flashers in the cockpit.In addition, a reliability is given. This means:If the accessory indicators fail due to an electronic fault, an error message is immediately displayed in the cockpit.Up to 2 channels can be operated, such as turn signals at the rear left and turn signals at the rear right.The CBW1 can also be used on vehicles with original LED turn signal equipment.The following resistance values ??can be set:150 ohms170 ohms240 ohms300 ohms400 ohms600 ohms1200 ohmsDimensions:Height = 11mmWidth = 31mm (without straps)Width = 46mm (with tabs)Length = 40mmCable length = 200mm with pinsConnections:Yellow = input channel 1 (+)Orange = output channel 1 (+)Blue = input channel 2 (+)Red = output channel 2 (+)Gray = input mass (-)Black = output ground (-)Scope of delivery: 1 pieceHints:• Up to 2 channels can be operated.• The connection is explained exactly in the operating instructions!